I have so many nice photos I have decided to put a gallery here for those who are interested. There is no text just pictures. It is a shame that the pictures had to be downsized.
December 20, 2009
November 22, 2009
Window to my workshop 29
No 982 smoothing plane in the making – 7
Just a few pictures of the wip of the adjuster mechanism for the No 982. I seem to miss a lot of photo opportunities but I will use the few I have got.
Pictures showing some of the milling operations for the main adjuster body. The making of this component also includes some lathe work which is not shown.
November 5, 2009
Window to my workshop 28
Spiers Style Shoulder plane -4
Apologies for the 4 week gap in postings for those of you who have been following my blog. I have been a bit busy with visitors (though always welcome it does tend to put me behind a bit), and the new project (transitional plane) keeps on snapping at me; it is coming along quite well if a bit piecemeal.
As I mentioned in the last posting that I had mislaid some pictures so here I am going to replace them with some from an A7 Norris type shoulder plane as they are very close in construction.
The front infill of an adjustable shoulder plane is probably the most complex infill of all my planes; especially as they are part of the adjuster design. This infill is integral with the bridge and the clamping screw bush. The clamping screw bush (which is illustrated in a previous posting) is screwed through the bridge. It also has a shoulder which secures the front part of the infill by clamping down on to a counterbore recess in the wood. This arrangement eliminates the need for a rivet here.
All the boring, counterboring and tapping is done in a set sequence whilst everything is in situ. After this process the whole plane is disassembled for further work. This includes the fixing of the infill to the bridge with the brass bush. With the fixing secure and complete the brass bush on the underside of the bridge can then be flushed off. By offering the filling back into position in the plane I can scribe the contour lines from the plane sides for reference for the shaping of the horn detail around the brass bush.
Here the rear end of the shoulder plane is polished before the blade bed is fitted, otherwise it would be inaccessible. This is typical of the importance of getting the sequence right throughout the whole project.
October 4, 2009
Window to my Workshop 27
Spiers Style Shoulder plane - 3
I seem to have misplaced a few pictures along the way here but the blog is only intended as a glimpse of what goes on.
At this stage with the plane temporarily assembled I drill through the horn and the bridge with a pilot drill.
(more…)
October 3, 2009
Window to my Workshop 26
Spiers Style Shoulder plane – 2
Difficult to define a name for this component; It certainly is a bush and it is threaded into the plane’s bridge which will also hold down one end of the front infill through the horn. This component also has an internal thread for the thumb screw that clamps the wedge. The picture shows a temporary screw driver slot being cut which will be removed after assembly.