The bullnose and shoulder plane blades must be the most work intensive. Once finished I celebrate with a photo!
Infill/adjuster housing/plane bed – whatever
Always a good feeling when nearing completion, although there is still a lot of fitting and finishing after they are separated.
Exquisite design. Your workmanship has not been equalled.
Comment by Bruce Mack — June 21, 2014 @ 5:26 pm
Very nice work. I have followed you blog and always wondered about the milky stuff you use for “coolant”. What is this stuff and do you use it on all your machines? I figured that some of the older machines would rust or get full of yuckie sticky stuff if you used this stuff. Your work is truly off the chain! You are the king of infill.
Comment by devmeister — April 7, 2015 @ 12:32 am